News

If you’re looking for beginner-friendly joinery, there’s no better starting place than half lap joints. Half laps come in all shapes and sizes: C...

Everyone knows calipers have jaws for outside and inside measurements. Most people know the little bar at the bottom is a depth gauge. But a lot ...

Want to get the most out of your table saw? You need to build some sleds. Sleds are jigs designed to slide past the table saw blade, either with ...

Squaring the corners of a mortise is a make or break moment. If you don’t place the chisel just right — or put too much pressure the wrong way — ...

For power tool woodworkers, the table saw is the beating heart of the shop. But it’s also the tool that causes the most injuries. You don’t w...

Removing glue squeeze-out from inside corners is a pain in the butt — and a major offender for blotchy finishes. Think about the inside corners o...

Want to add strength and a decorative touch to your miter joints? Splines are just the ticket. Miter joints are simple to make a...

Table saws are the beating heart of many woodshops. But if you’re not using the right blade, you’re not going to get the best results. Have you b...

Sharpening a hand plane iron isn’t difficult — but there are a few critical elements for getting it right. For example, when are...